(Solved) Ktag 6.070 Warning: Mandatory Update

Look here: Ktag 6.070 token issues SOLVED

Ktag version:

Ktag firmware version 6.070

Error message:

ktag warning: mandatory update within the next 5 programming. connect the tool to the internet and run the update as soon as possible

Solution:

There are only 5 tokens left, so you need to reset tokens.

You need:

1. Reset tokens for Ktag. 6.070 is the Unlimited tokens version, no need desolder chips.
   We add tokens programming software on the CD. Once tokens run over, follow our video to program tokens step by step. No need remove the token chip from the main board, no need desolder chips.
2. If still not works, pls replace the TF card and reset tokens again.

Video: reset tokens for Ktag fw6.070

VERY IMPORTANT:

DO NOT connect to the network!

Otherwise, you might have an issue of block and need send the machine back for repair.

Pls. check with Ktag you have and contact the support for methods to reset tokens

Ktag list:

http://www.obdii365.com/producttags/ktag.html

The best is to have a Ktag 7.020

http://www.obdii365.com/wholesale/ktag-v7020-red-pcb-online-version.html

This is an online version. No need worry about network connection!

And it has not a reset button and without token limitation!